Turbocrete

Turbocrete is a pre-bagged dry shotcrete mix for use in underground support, rockface lining, or in structural repair situations.

 

Advantages

  • Turbocrete provides a choice of steel fibre reinforcing or polypropylene fibre reinforcing, allowing support characteristics to be met.
  • Turbocrete provides secondary support in areas where early strength gain is required.
  • Mix design is optimised to reduce rebound losses.
  • Turbocrete achieves a minimum of 30 MPa strength at 28 days when correct water/cement ratios are used.

 

Composition Description
OPC CEM 1 42,5
Optional extenders - Silica Fume / GGBS / PFA As required
Optional Admixtures Plasticisers & accelerators
Fine Aggregate Crusher / River / Filler Sands ≤ 5% moisture content
Coarse Aggregate Crushed stone

 

Standards Compliance
Turbocrete materials comply with the requirements of SABS ENV197-1, 1083, 1200G & 1491-1/2/3.

 

Range of Products

Product Bag size Compressive Strength @ 28 days
Turbocrete (standard) 25kg/30kg 30 MPa min.
Turbocrete (Polyfibre) 25kg/30kg 30 MPa min.
Turbocrete (steel fibre) 25kg/30kg 30 MPa min.

 

Yield

Bag size Yield per m³
25 kg ± 93 bags
30 kg ± 77 bags

 

Fibres

  Type Size Mass/m3 of Shotcrete
Steel Non-balling deformed steel fibre 30-35mm 25 - 50 kg
Polymer Polypropylene - Strand or fibrillated 25-45mm 3,5 - 10 kg

 

Packaging

Outer bag Inner bag
Virgin, woven, pre-printed, polypropylene bag, with stitched polyester seams. Colour coded for easy identification of product. Virgin, low density, polyethylene bag with heat-sealed sides and bottom seams.

 

Storage
Materials should normally be stored under cover. Reduced shelf life may occur if packaging is exposed to the elements. Packaging materials may deteriorate, allowing moisture ingress into the cementitious binder. This could lead to premature hardening.

 

Shelf Life
Turbocrete products will store for up to 6 months in dry conditions.

 

Safety

General The use of eye protection, gloves and dust masks is recommended. Follow the typical precautions as prescribed for handling Portland cement.
Inhalation Constant exposure over long periods of time to very high concentrations may cause a cough with phlegm.
Skin contact Prolonged exposure could sensitize skin causing mild irritation. In extreme cases, dermatitis could occur.
Eyes Use eye protection. However, if eyes become affected, irrigate eyes with copious amounts of clean water. Seek medical attention.
Ingestion Ingestion of harmful quantities is unlikely to occur. If ingested, drink copious amounts of drinking water and consult a medical practitioner. DO NOT INDUCE VOMITING.

 

Technical Support, Servicing and Testing
Technicrete provides full support and back-up on both the technical and practical aspects of our products. We provide on-site assistance and underground training. All product performance is continuously monitored by means of regular testing at accredited laboratories.

 

Important Note
Technicrete products are guaranteed against defective materials and manufacture and are sold subject to its standard terms and conditions of sale. Whilst Technicrete endeavours to ensure that any advice, recommendation, specification or information it may give is accurate and correct, it cannot, because it has no direct or continuous control over where and how its products are applied, accept any liability either directly or indirectly arising from the use of its products, whether or not in accordance with any advice, specification, recommendation or information given by it.